Docs
Digital Oscilloscope - 2 Channel
Digital Oscilloscope - 2 Channel
Advanced code blocks with highlighting, file names and more.
Technical Specifications:
| Oscilloscope | |
|---|---|
| Sample rate | 1GSa/s (single channel) 500MSa/s (two channels) |
| Peak-to-peak value | Display high frequency and random burr |
| Average | Average waveform, times: 4, 8, 16, 32, 64, 128 |
| High resolution | Up to 12bit |
| Input coupling | DC, AC, GND |
| Input impedance | 1MΩ±2% ‖20pF±3pF |
| Probe attenuation factor | 1X, 10X, 100X, 1000X |
| Voltage rating | 300V CAT II |
| Maximum input voltage | 300 VRMS (10X) |
| Horizontal | |
| Waveform interpolation | (sin x)/x |
| Maximum record length | Single channel maximum 8M,Two channels maximum 4M |
| Horizontal scale range | 2ns/div~100s/div 1, 2, 5 step by step |
| Time base mode | Y-T, X-Y, Roll |
| Zero offset | ± 0.5 div × minimum time base gear |
| Sample Rate and Delay Time Accuracy | ±25ppm |
| Delta Time Measurement Accuracy (Full Bandwidth)Sample Rate and Delay Time Accuracy | single-shot, Normal mode ± 1 sample interval+100ppm×reading+0.6ns |
| ＞16 times averages ±（1 sample interval+100ppm×reading+0.4ns） | |
| Sample interval=sec/div÷200 | |
| Sample Rate and Delay Time Accuracy | ±50ppm（at any interval greater than 1ms） |
| Vertical | |
| Vertical resolution | 8 bits resolution, each channel samples simultaneously |
| Vertical sensitivity | 2mV/div to 10V/div |
| Vertical gain accuracy | In ”normal” or ”average” acquisition mode, the accuracy of 10V/div to 10mV/div is ±3% |
| In ”normal” or ”average” acquisition mode, the accuracy of 5mV/div to 2mV/div is ±4% | |
| Note: Bandwidth reduced to 6MHz when using a 1X probe | |
| Trigger type | Edge, Pulse width, Video, Slope, Overtime, Window, Pattern, Interval, Under Amp, UART, LIN, CAN, SPI, IIC |
